PARTNERED WITH

During the installation process, the installers will remove as much of the mounting solution as possible, although a small amount will remain. Trapped installation moisture can cause small water bubbles and/or a slightly cloudy look. This is normal and should be expected. Do not attempt to pierce a water bubble in an effort to drain moisture.

Cold and non-sunny weather conditions can lengthen the dry-out time. Warm weather and direct sunlight exposure will shorten the dry-out time. If slow drying occurs, do not become alarmed. The trapped moisture will dry out completely. Safety and Security films will always have a longer dry-out period due to increased thickness of the film. Thicker films and less than perfect drying climate will lengthen the dry-out period. Dry-out can vary from a few days to as much as 6 months.

DO NOT clean film sooner than 30 days after installation. This will allow proper curing of the adhesive.

Two effective and economical cleaning solutions is 1/2 ounce of liquid dish soap added to 1 quart of fresh water, or Windex.

A clean soft cloth or clean synthetic sponge is recommended for washing the window film, followed by another clean soft cloth or soft rubber squeegee for drying. DO NOT use abrasive materials to clean your film. Avoid using bristle brushes, abrasive scrubbing sponges or any other cleaning materials that could scratch your film. Some brands of paper towels are coarse enough to put fine scratches in the film - even films with scratch resistant coating. While these scratches may be too thin to see in the beginning, they can damage the polished look of the film over time. Always use soft clean materials to wash and dry your window film.